超薄cpt7寸tft数字液晶屏(50pin)(3.4mm厚)

11.0  general precaution
11.1 use restriction
this product is not authorized for use in life supporting systems, aircraft navigation control
 systems, military systems and any other application where performance failure could be
 life threatening or otherwise catastrophic.
 
11.2 disassembling or modification
 do not disassemble or modify the module. it may damage sensitive parts inside lcd
 module, and may cause scratches or dust on the display. hannstar does not warrant the
 module, if customers disassemble or modify the module.
 
11.3 breakage of lcd panel
11.3.1.if lcd panel is broken and liquid crystal spills out, do not ingest or inhale liquid 
crystal, and do not contact liquid crystal with skin.
11.3.2. if liquid crystal contacts mouth or eyes, rinse out with water immediately.
11.3.3. if liquid crystal contacts skin or cloths, wash it off immediately with alcohol and 
rinse thoroughly with water.
11.3.4. handle carefully with chips of glass that may cause injury, when the glass is 
broken.
 
11.4 electric shock
11.4.1. disconnect power supply before handling lcd module.
11.4.2. do not pull or fold the led cable.
11.4.3. do not touch the parts inside lcd modules and the fluorescent led!fls connector
   or cables in order to prevent electric shock.
 
11.5 absolute maximum ratings and power protection circuit
11.5.1. do not exceed the absolute maximum rating values, such as the supply voltage 
variation, input voltage variation, variation in parts!fl parameters, environmental
temperature, etc., otherwise lcd module may be damaged.
11.5.2. please do not leave lcd module in the environment of high humidity and high 
temperature for a long time.
11.5.3. it!fls recommended to employ protection circit for power supply.
 
11.6 operation
11.6.1 do not touch, push or rub the polarizer with anything harder than hb pencil lead.
11.6.2 use fingerstalls of soft gloves in order to keep clean display quality, when persons 
handle the lcd module for incoming inspection or assembly.
11.6.3 when the surface is dusty, please wipe gently with absorbent cotton or other soft 
material.

11.6.4 wipe off saliva or water drops as soon as possible. if saliva or water drops contact 
with polarizer for a long time, they may causes deformation or color fading.
11.6.5 when cleaning the adhesives, please use absorbent cotton wetted with a little 
petroleum benzine or other adequate solvent.
 
11.7 mechanism
please mount lcd module by using mouting holes arranged in four corners tightly.
 
11.8 static electricity
11.8.1 protection film must remove very slowly from the surface of lcd module to 
 prevent from electrostatic occurrence.
11.8.2. because lcd module use cmos-ic on circuit board and tft-lcd panel, it is very 
 weak to electrostatic discharge. please be careful with electrostatic discharge. 
 persons who handle the module should be grounded through adequate methods.
 
11.9 strong light exposure
  the module shall not be exposed under strong light such as direct sunlight. otherwise, 
 display characteristics may be changed.
 
11.10 disposal
 when disposing lcd module, obey the local environmental regulations.